What Remote Control and Monitoring Can Do For You


Our remote monitoring and control system has countless uses and advantages.

Unless you have accurate information about what energy you use, it is difficult to make savings. With this system you can monitor any installation, make control changes to lighting, heating or equipment settings without going to the site - and then retest and make any necessary adjustments.

By being able to monitor remote equipment without going to site can save many hours of traveling time, fuel and vehicle maintenance while providing a better service to your customers and clients.

Reduce Overheads...Save Energy...Save Money...Stay in Control


 
 

Remote Control...
This makes life so much easier and can give peace of mind knowing you can make quick changes if and when required.

By knowing quickly if a piece of equipment has failed, this makes maximum use of maintenance staff and a quick response can sometimes save system major restart problems. For example this could reduce the risk of flood damage if a drainage pump failed or reduce risk of livestock dying from cold if heating fails

Having up to date fault reports in the screens enables maintenance managers to fully know their work loadings such as what has failed. Making the most efficient use of staff dramatically improves customer service by having an engineer on site sometimes even before the customer knows there is a problem!

   
Energy Managers...
Energy managers can use a portable test case system to measure what they need to know and then take the case to another site and decide if the potential economies are worth making changes. Alternatively, installing permanent monitoring systems. With our WattsOn box, we can show, import and export readings kwh kva kvar/voltage/amps/power factor for all three phases.
   
Farmers...
Farmers have equipment, livestock and greenhouse crops in many remote locations. Failure of this equipment can be expensive and cause risk to chickens, piglets and other animals. This equipment can monitor your valuable assets provided you have a mobile phone signal; it can be wind or solar powered if necessary.
   
Commissioning Engineers...
Commissioning engineers are always overloaded and are looking for ways to reduce time traveling to site. Being able to know the urgency of going to a particular site can dramatically reduce overheads together with improving customer service. Further, getting charts of selected parameters are always very helpful in getting the best out of the system and being able to prove the system complies with the specification.
   
Maintenance Managers...
Maintenance Managers can both reduce the number of site visits or go having better information about what has gone wrong, enabling them to send the suitable engineer. Companies with planned maintenance contracts where the system was not large enough to have a full BMS with telementary can have this system added to vital equipment. When under pressure, it can make all the difference if a planned visit can be deferred.
   
Production Engineers...
Production engineers who often only work day shifts want to know what is happening with the system. Out of normal working hours helps to give advice to on duty staff by being able to see what is happening on site or making changes over the system.
   
Vending Machines, etc...
Vending machines, pin tables, ticket machines and other equipment with limited fault signals can be directly connected to the interface box. This can perform multiple tasks such as inform of low stock levels, jammed mechanisms, full coin boxes, etc. They can also transit location information as well as any faults.
   
Alternative Energy...
Alternative energy is a fantastic help but knowing how well it is working is essential. With remote monitoring it is possible to receive, record and monitor such information as the electricity produced, wet energy and how wind speed is affecting things. Until recently this type of equipment has been only been available for large systems, our system allows it to be economic for smaller situations. With our WattsOn box, we can show, import and export readings kwh kva kvar/voltage/amps/power factor for all three phases.

 


Monitorhawk remote control - tell us what you need to know

 

Facebook and Twitter links here